After each one, press Enter.Įnter security code (“CID”, a.k.a.
PAX S80 CREDIT CARD TERMINAL MANUAL MANUAL
This will take you to the Card Number screen, and then other manual card info screens. (Also called a “Keyed” transaction.) You still use the Payment Terminal Device, but instead of swiping a card, start typing the card number on the keypad. If the card doesn’t read correctly, or you’re taking a phone order w/o the card present, you’ll have to enter the card info manually. Processing a Payment: A keyed (manual card entry) sale Thank You message (Transaction Approved): Otherwise, swipe it in the magnetic stripe reader slot on the right side of the device (up-down or down-up). Once EMV is enabled, if the credit card has a chip in it, you can insert it,chip first, in the slot at the front of the device, under the keyboard. You’ll see a screen similar to the following, on the payment terminal device: Once the device is set up properly, and Artisan POS and the PaygistiX Client are installed and configured correctly, you can ring up a sale through the POS. Processing a Payment: Doing a Normal Sale Payment Logistics may only your IP Address.
Network Settings you need to give Payment Logistics to finish the configuration: IP Address, Subnet Mask, Gateway IP, and DNS IP.
The password is today’s date (or sometimes tomorrow’s date), as 4 digits: mmdd.įrom the Main Menu, select “6. To enter the setup screens on the SP30, press the ” F ” key on the upper part of the device. Once you’ve plugged the device into power and your network (LAN), you’ll need to read out its network settings for Payment Logistics to use to configure your Client software. Follow the images in this section to navigate to the Network Settings screens on the device. Payment Logistics will help you with the rest of the setup. This is the one that would be used to connect the device to the network. This article shows the PAX SP30 Payment Terminal from Payment Logistics in the following order:įirst make sure the “LAN” cord is identified.